Solas Dynafly Impeller for Sea-Doo ST-DF-14/20 - Watercraft Superstore
0

Your Cart is Empty

Solas Dynafly Impeller for Sea-Doo ST-DF-14/20

607SO097

SPECIAL ORDER ONLY Dynafly Maximum Acceleration Our new impeller is designed to give high compression ratio pumps a stronger acceleration with less cavitation. This impeller is capable of giving your PWC an incredible boost in its performance. The SOLAS product line includes Dynafly impellers for the Kawasaki Ultra 150 pump and the Sea Doo 951 pump. SOLAS also has developed new impellers for other pumps. Please check the application chart for further details.
1.)Remove and separate the whole jet pump from the PWC

2.)Remove the trail cone (or cap) from the stator

3.)Hold the rear end of the shaft with a bench vise. Remove the impeller with an impeller wrench. Turning counter clockwise will loosen the impeller.

4.)Visually inspect thread on shaft and impeller for debris or damage. Apply grease or anti-seize on the thread before installation.

5.)Screw the impeller by hand; please be careful of the sharp edge of the impeller. Tighten with the impeller wrench. If the impeller feels too tight or not threaded properly, unscrew the impeller, clean and check the thread.

6.)Assemble the pump and refill O/E pump oil or grease to spec.

*this installation guide is suggested for reference only
*please refer to your original service manual or contact your PWC dealer for detail
*guide provided by Solas
*some wrenches are optional parts and are available for purchase on our website

Impeller Series

Wrench

Seal

SD Super Camber (ABC Series)

WR001

SL007

SD Super Camber (IJK Series)

WR001

SL007

SD, ST Xprop Series

WR001

SL007

SD, SF, ST Concord Series

WR001

SL007

ST Dynafly Series

WR001

SL007

SR Concord Series

WR011

SLA011 (24mm shaft)
SLA011A (27mm shaft)

SRZ, SRX Concord Series

WR012

SLA012