Solas Xprop Impeller for Sea-Doo ST-SC-XI (15.5-18.5) - Watercraft Superstore
0

Your Cart is Empty

Solas Xprop Impeller for Sea-Doo ST-SC-XI (15.5-18.5)

607SO099

X-prop - High Speed & Ultimate Performance. The SOLAS X prop gives you the most powerful propulsion in the water from an advanced design that incorporates a high compression hub and cambered blades. Enthusiasts looking for speed and acceleration from the novice to the professional will be satisfied using this impeller. You can trust the harsh field testing of the X prop by Team SOLAS.
1.)Remove and separate the whole jet pump from the PWC

2.)Remove the trail cone (or cap) from the stator

3.)Hold the rear end of the shaft with a bench vise. Remove the impeller with an impeller wrench. Turning counter clockwise will loosen the impeller.

4.)Visually inspect thread on shaft and impeller for debris or damage. Apply grease or anti-seize on the thread before installation.

5.)Screw the impeller by hand; please be careful of the sharp edge of the impeller. Tighten with the impeller wrench. If the impeller feels too tight or not threaded properly, unscrew the impeller, clean and check the thread.

6.)Assemble the pump and refill O/E pump oil or grease to spec.

*this installation guide is suggested for reference only
*please refer to your original service manual or contact your PWC dealer for detail
*guide provided by Solas
*some wrenches are optional parts and are available for purchase on our website

Impeller Series

Wrench

Seal

SD Super Camber (ABC Series)

WR001

SL007

SD Super Camber (IJK Series)

WR001

SL007

SD, ST Xprop Series

WR001

SL007

SD, SF, ST Concord Series

WR001

SL007

ST Dynafly Series

WR001

SL007

SR Concord Series

WR011

SLA011 (24mm shaft)
SLA011A (27mm shaft)

SRZ, SRX Concord Series

WR012

SLA012