$208.85
Solas IJK Impeller for Polaris PA-SC-I (15-24)
Brand: Solas
SKU #: 607SO055
Shipping Weight: 4.00 pounds
Quantity in Basket:
None
Super Camber A-B-C-D-E - For a Cost Effective Solution. The Super Camber A-B-C-D-E series remains one of the most popular products in the personal watercraft market. The Super Camber blade has increased flow and the thrust of the impeller.
WARNING: This product can expose you to chemicals which are knownn to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to https://www.P65Warnings.ca.gov.
2000 - 2002 Pro 1200
2000 - 2002 Virage TX Virage TXi
2000 - 2002 Virage TX Virage TXi
1)Remove and separate the whole jet pump from the PWC
2)Remove the trail cone (or cap) from the stator
3)Hold the rear end of the shaft with a bench vise. Remove the impeller with an impeller wrench. Turning counter clockwise will loosen the impeller.
4)Visually inspect thread on shaft and impeller for debris or damage. Apply grease or anti-seize on the thread before installation.
5)Screw the impeller by hand; please be careful of the sharp edge of the impeller. Tighten with the impeller wrench. If the impeller feels too tight or not threaded properly, unscrew the impeller, clean and check the thread.
6)Assemble the pump and put it back on the PWC.
*this installation guide is suggested for reference only
*please refer to your original service manual or contact your PWC dealer for detail
*guide provided by Solas
*some wrenches are optional parts and are available for purchase on our website
2)Remove the trail cone (or cap) from the stator
3)Hold the rear end of the shaft with a bench vise. Remove the impeller with an impeller wrench. Turning counter clockwise will loosen the impeller.
4)Visually inspect thread on shaft and impeller for debris or damage. Apply grease or anti-seize on the thread before installation.
5)Screw the impeller by hand; please be careful of the sharp edge of the impeller. Tighten with the impeller wrench. If the impeller feels too tight or not threaded properly, unscrew the impeller, clean and check the thread.
6)Assemble the pump and put it back on the PWC.
*this installation guide is suggested for reference only
*please refer to your original service manual or contact your PWC dealer for detail
*guide provided by Solas
*some wrenches are optional parts and are available for purchase on our website
Impeller Series | Wrench | Seal |
HA Concord Series | WR001 | SLA010 |
PL Super Camber (ABC/IJK Series) | WR006 | SL006 |
PA Super Camber (ABC/IJK Series) | WR006 | SL006, SL012 |
PF Concord Series | WR006 | SL009 |
